A transformer takes in electricity at a higher voltage and lets it run through lots of coils wound around an iron core. Because the current is alternating, the magnetism in the core is also alternating. Also around the core is an output wire with fewer coils. The magnetism changing back and forth makes a current in the wire. Having fewer coils means less voltage. So the voltage is “stepped-down.”

The following are three different kinds of transformers:

l       Three-phase transformers.

A basic 3-phase transformer consists of three sets of primary windings, one for each phase, and three sets of secondary windings wound on the same iron core. Separate single phase transformers can be used and externally interconnected to yield the same results as a 3-phase unit.

The primary windings are connected in one of several ways. The two most common configurations are the delta, in which the polarity end of one winding is connected to the non-polarity end of the next, and the wye, in which all three non-polarity (or polarity) ends are connected together. The secondary windings are connected similarly. This means that a 3-phase transformer can have its primary and secondary windings connected the same (delta-delta or wye-wye), or differently (delta-wye or wye-delta). It’s important to remember that the secondary voltage waveforms are in phase with the primary waveforms when the primary and secondary windings are connected the same way. This condition is called “no phase shift.” But when the primary and secondary windings are connected differently, the secondary voltage waveforms will differ from the corresponding primary voltage waveforms by 30 electrical degrees. This is called a 30? phase shift. When two transformers are connected in parallel, their phase shifts must be identical; if not, a short circuit will occur when the transformers are energized.

l       Autotransformers.

An autotransformer is a transformer with an electrical connection between the primary and secondary windings. Autotransformers have considerably more MVA capacity per pound of core iron and winding conductor than standard power transformers, but are limited to small turns rations — ideally 2:1.

Although the designs of different transformers vary extensively, their basic operation remains the same.

l       Special transformers.

Transformers can have more than two windings per phase. These designs help reduce fault current levels. Other transformers have been built to operate at relatively low voltages but extremely high currents. Arc furnace transformers fall into this category, and can have secondary current ratings in excess of 150,000A. Regulating transformers are designed to maintain their secondary voltage within specific limits as the primary voltage fluctuates. Transformers can also be built to shift phase a specified amount to control the flow of real power in a networked system.

You know there is a old Chinese saying: “There’s no such thing as a free lunch.” If you want to buy a flat like that, you must make sure that it does no harm to you!

A high-voltage substation must contain many high-voltage equipments, such as transformer, Converter, High Voltage Transmission Lines and so on. Besides high-voltage may produce electromagnetic radiation around.

Attention! it does harm to our body. Now let me tell you some hazards to human by High-voltage substation’s electromagnetic radiation:

Transformer

1. It is very likely one reason that children suffer from leukemia.
2. Able to induce cancer and accelerate the proliferation of human cancer cells.
3. Affect the reproductive system.
4. Can lead to missing children’s intelligence.
5. The human visual system is affected.
6. Noise pollution.
7. Fire and explosion.
8. High lighting hazard areas.
9. The leakage of toxic chemicals.

Oh, my God! How dare a person live in such houses, at least not me!